There are 1556 products.
Active filters
Lightweight Carbon Rear Shaft for the FANTOM EP 4WD. Improves throttle response by lighter rotating parts. The screw part at tip of differential side is assembled with aluminum parts by factory. Recommended to use with EFW003.
Tie-rod set for the MA-03F/MA-030. Provides four steps of toe angle setup for each narrow and wide configuration.
<Readyset Contents>
●Fully assembled and painted chassis
●3ch transmitter
<Required for Operation>
●1 x PP3 9V alkaline battery for transmitter
●4 x AAA alkaline batteries for model
Optional parts for the INFERNO MP9/MP10.
Allows to change the inside center differential gear ratio from 10T/20T to 12T/18T.
By changing the differential effect, improve running stability on bumpy track
Increased a setting variety.
●FH5U: SXR(SANWA XTREME RESPONSE) MODE-COMPATIBLE
●SSL-COMPATIBLE PROGRAMMABLE SERVO
# Compatible with CODE 10 (M12S, EXZES ZZ, MT-44)
Not Compatible with CODE 5 (M12, EXZES Z, MT-4S, MT-4, MT-S)
●PGS SETTING GEAR-COMPATIBLE
●SUPER RESPONSE (SSR) MODE-COMPATIBLE
●HIGH RESPONSE (SHR) MODE-COMPATIBLE
●Li-Po 2 CELL-COMPATIBLE
●HIGH TORQUE TYPE
●BRUSH LESS MOTOR
●FULL ALUMINUM CASE
●FULL METAL GEAR (Strengthening Gears)
●AL HEAT SINK
●Black Harness
Spare parts for Javelin. Compatible with the Optima to use the Javelin roll cage body.
Pit mat with cool MINI-Z logos.
Great for maintanance of your MINI-Z while keeping the pit table clean.
Soft and grippy PVC material avoids small parts to fall off the table.
Size: 24 in. x 17 in. (approx 600 x 430mm).
Light weight 2.5mm carbon fiber shock tower. Compared to the stock aluminum shock tower the carbon fiber shock tower is much lighter and with the same durability
Light weight 2.0mm carbon fiber side plates. 5g lighter without compromising the durability.
Light weight 2.5mm carbon fiber plate. Same durability as the stock plates but 5g lighter.
Optional parts for the TURBO OPTIMA.
Color variation of 50mm wheel.
When use with #OTT244M, it can be used as optional parts for the OPTIMA and JAVELIN.
Turns：15.5Ｔ
Operating Voltage：1-3Ｓ／12.6Ｖ
RPM@7.4V：18870
KV（RPM／V）：2550
Max Current：38A
Max Power：320W
Efficiency：90％
Weight（g）：179
Motor Diameter（mm）：35.8
Motor Length（mm）：51.2
Shaft Length（mm）：15
Shaft Diameter（mm）：3.175
3 types of wire diameters can be chosen for both front and rear. Provides a wide range of setting options
■Length 430mm
■Width 197mm
■Ground Clearance 5mm approx.
■Wheelbase 270mm
■Tread (F/R) 164mm / 166～172mm
■Wheel（F/R） Φ36mm x 30mm / Φ36mm x 45mm
■Weight 1,100g approx.
■Motor Brushless (sold separately)
Required for operation
●2-channel, 1 servo R/C system for cars
●Brushless motor
●ESC for brushless motor
●Battery
●Battery charger for chassis battery
●Tires
●1/10 Formula car body
●Tools
●Paint for body
●Batteries for R/C system
